Eotech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illum Manuel d'utilisateur télécharger pdf (Page 48)

2-22

2.8 USING THE LASERS - Continued

a. Uses an Illuminator Diffuser over the IR Illuminator

identical to that described for the Tri-Function Lens

Cap.

b. Uses a Pattern Generator to project a specific

holographic design over the aim points of both the

Visible and IR Aim Lasers resulting in a 2.6m shape

at 300m (see Figure 2-12). Shapes are visible with

the naked eye if using the Visible Aim Laser and

with night vision devices if using the IR Aim Laser.

Figure 2-12 Pattern Generator Shapes

IR Illuminator Pulse Mode

In addition to momentary and continuous modes of

operation, the IR Illuminator may be programmed to operate

in pulse mode at either 1, 4, or 8 pulses per second.

Programming the IR Illuminator pulse rate is accomplished

as follows:

a. With the Mode Selector turned to the O (OFF)

position, hold down the FIRE Button.

b. Turn the Mode Selector to the desired pulse rate as

shown in Table 2-6. The rate will display on the LED

Status Indicator (the LED will flash green the same

number of times as the Illuminator pulse rate).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 73 74

Pas de commentaire

Eotech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illum Manuel d'utilisateur Page 48