Eotech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illum Manuel d'utilisateur télécharger pdf (Page 28)

2-2

2.2 BATTERY HANDLING

Battery Inspection

Before installation, inspect the 3-volt lithium batteries for any

cracks, dents, leakage, or bulging. Never install a defective

battery in the MIPIM.

Battery Installation

WARNING

Ensure the Mode Selector is turned to the O (OFF)

position before attempting to install, remove, or

replace batteries.

WARNING

Do not store the MIPIM with batteries installed.

NOTE

Proper battery orientation is clearly marked on the

label near the battery compartment.

1. Unscrew the battery cap.

2. Tilt the MIPIM as shown in Figure 2-1 and install the first

DL123A lithium battery with the positive terminal facing in.

If necessary, gently shake the MIPIM to properly seat the

battery.

3. Install the second battery with the positive terminal facing

out.

4. Replace and tighten the battery cap.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 73 74

Pas de commentaire

Eotech MIPIM (AN/PEQ-16B) - Mini Integrated Pointer Illum Manuel d'utilisateur Page 28